EasyManua.ls Logo

Intek MT-4040 - Operation - Settings; TX Output Power and Key Tone; Roger Beep and Call Tone Settings

Intek MT-4040
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
To get full advantage of the convenience of a hands-free transmission and the privacy of conversation, you can
purchase an optional external Earset-Microphone. Please do not use accessories other than the original ones
(please refer to the Optional Accessories list in this manual).
To use the Ear Bud:
1. Set your radio to VOX Mode.
2. Insert the Ear Bud Jack into the MIC/CHG.
3. Wear the Ear Bud and adjust the Microphone location.
Changing the TX Output Power
Your radio has a Hi/Low Power selection function to set the TX Power for PMR Band. To select the output power on
the PMR Band :
1. Enter to Menu mode. Advance through the Menu until the “Pr” icon appears on the LCD Display.
2. Press the Up or Down key to set the Power to Hi or Low.
3. To exit the Menu, press PTT or Call key.
Note : this function is available only on the 8 PMR channels.
Setting the Key Tone Feature
The Keypad Tone of your radio can be activated and disabled according to your preference. To set the Key Tone :
1. Enter to Menu mode. Advance through the Menu until the tone icon (6) appears on the display.
2. Press the Up or Down key to toggle between On and Off function of the Key Beep Tone.
3. To exit the Menu, press PTT or Call key.
Setting the Roger Beep Tone Feature
Your radio is equipped with a user selectable Roger Beep Tone feature, which enables you to send a Beep Tone at
the end of each transmission after every release of the TALK key. This will prompt any receiving unit that your
transmission has ended.
1. Enter to Menu mode. Advance through the Menu until the “Roger Beep” icon (7) appears on the display.
2. Press the Up or Down key to toggle between On and Off function of the Roger Beep Tone.
3. To exit the Menu, press PTT or Call key.
Setting the Call Tone
Your radio is equipped with 3 user selectable Call Tone melodies. To set the desired Call Tone melody :
1. Enter to Menu mode. Advance through the Menu until the “CA” icon appears on the display.
2. Press the Up or Down key to toggle between 1~3 choices of Call Tone pattern.
3. To exit the Menu, press PTT or Call key.
- 12 -
Operation
English

Other manuals for Intek MT-4040

Related product manuals