11
Caution: Users should not attempt to make such connections themselves, but should contact the
appropriate electric inspection authority, or an electrician, as appropriate.
Power Cord Requirement
The power cord supplied with the AC adapter should match the plug and voltage requirements for your
local area. Regulatory approval for the AC adapter has been obtained using the power cord for the local
area.
However, if you travel to a different area and need to connect to a different outlet or voltage, you
should use one of the power cords listed below. To purchase a power cord (including one for a country
not listed below) or a replacement AC adapter, contact your local dealer.
US and Canada
The cord set must be UL/ETL-listed and CSA-certified or UL/C-ETL listed.
The minimum specifications for the flexible cord are (1) No. 18 AWG, (2) Type SPT-2, and (3) 2-
conductor.
The cord set must have a rated current capacity of at least 7A.
The attachment plug must be NEMA 1-15P (7A, 125V) configuration.
Other Countries
The cord set fittings must bear the certification mark of the agency responsible for evaluation in
a specific country. Acceptable agencies are:
o CCC (China)
The flexible cord must be of a HAR (harmonized) type HO5VV-F 3-conductor cord with a
minimum conductor size of 0.03 square inches.
The minimum specification for the flexible cord for Class II product are: (1) 2 x 0.75mm²
conductors, (2) 2-conductor cord.
The cord set must have a current capacity of at least 10 A and a nominal voltage rating of
125/250 VAC.
Note: This model is designed to be used with the following AC Adapter models only.
Manufacturer – Shenzhen Huntkey Electric Co., LTD
o Model – HKA03619021-8C (AC 2-pin)
Manufacturer – Delta Electronic, INC.
o Model – ADP-40PH AB (AC 2-pin)
Battery Pack Safety
The battery pack is intended to be used only with this notebook.
Only qualified service technicians should replace the battery pack.
Do not disassemble the battery pack.
Do not dispose of the battery pack in fire or water.
To avoid risk of fire, burns, or damage to your battery pack, do not allow a metal object to touch
the battery contacts.
Handle a damaged or leaking battery with extreme care. If you come in contact with the
electrolyte, wash the exposed area with soap and water. If it contacts the eye, flush the eye with
water for 15 minutes and seek medical attention.
Do not charge the battery pack if the ambient temperature exceeds 45ºC (113ºF).
To obtain a replacement battery, contact your local dealer.
To Next Page
Loading...
Need help?
General
