6 Intel Desktop Boards D845GRG and D845GBV
Quick Reference
For the latest information on processors supported by Desktop Boards
D845GRG and D845GBV, refer to the Intel World Wide Web site at:
http://support.intel.com/support/motherboards/desktop
Memory Module Requirements
The desktop boards supports system memory as defined below:
• Up to two 184-pin Double Data Rate (DDR) 200/266 SDRAM Dual Inline
Memory Modules (DIMMs) with gold-plated contacts
• Unbuffered and non-registered single or double-sided DIMMs
• Serial Presence Detect (SPD) memory only
• Non-ECC and ECC DIMMs
• 2.5 V memory
✏
NOTES
The Desktop Boards D845GRG and D845GBV have been designed to
support DIMMs based on 512 Mbit technology up to 2 GB, but this
technology has not been validated on these boards.
All memory components and DIMMs used with the desktop boards must
comply with the PC SDRAM specifications. These include the PC
SDRAM Specification (memory component specific), the PC Unbuffered
DIMM Specification. To view or download these specifications, refer to
this Intel World Wide Web site:
http://www.intel.com/technology/memory/pcsdram/
For information about vendors that support these memory requirements,
refer to the Desktop Boards D845GRG and D845GBV link on this Intel
World Wide Web site:
http://support.intel.com/support/motherboards/desktop/
Installation Steps
1 Installing the I/O Shield
The board comes with an I/O shield. When installed in the chassis, the shield
blocks radio frequency transmissions, necessary to pass emissions (EMI)
certification testing, protects internal components from dust and foreign objects,
and promotes correct airflow within the chassis.
Install the I/O shield before installing the board in the chassis. Place the shield
inside the chassis as shown in the following figure. Press the shield into place so
that it fits tightly and securely. If the shield doesn’t fit, obtain a properly sized
shield from the chassis supplier.
To Next Page
Need help?
General
