Installing and Replacing Desktop Board Components
31
Installing and Removing a Processor
Instructions on how to install the processor on the Desktop Board are given below.
Installing a Processor
CAUTION
Before installing or removing a processor, make sure the AC power has been removed
by unplugging the power cord from the computer; the standby power LED should not
be lit (see Figure 3 on page 25). Failure to do so could damage the processor and the
board.
T
o inst
all a processor, follow these instructions:
1. Observe the precautions in "Before You Begin" on page 27.
2. Un
latc
h the socket lever by pushing the lever down and away from the socket
(Figure 6, A and B).
Figure 6. Unlatch the Socket Lever
To Next Page
Loading...
Need help?
General
