Intel PRO/1000 GT User Manual

Intel® Ethernet iSCSI Boot Port Specific Setup Menu
The port specific iSCSI setup menu has four options:
l Intel® iSCSI Boot Configuration - Selecting this option will take you to the iSCSI Boot Configuration
Setup Menu. The iSCSI Boot Configuration Menu is described in detail in the section below and will
allow you to configure the iSCSI parameters for the selected network port.
l CHAP Configuration - Selecting this option will take you to the CHAP configuration screen. The
CHAP Configuration Menu is described in detail in the section below.
l Discard Changes and Exit - Selecting this option will discard all changes made in the iSCSI Boot
Configuration and CHAP Configuration setup screens, and return back to the iSCSI Boot Port Selec-
tion Menu.
l Save Changes and Exit - Selecting this option will save all changes made in the iSCSI Boot Con-
figuration and CHAP Configuration setup screens. After selecting this option, you will return to the
iSCSI Boot Port Selection Menu.
Intel® iSCSI Boot Configuration Menu
The Intel® iSCSI Boot Configuration Menu allows you to configure the iSCSI Boot and Internet Protocol (IP)
parameters for a specific port. The iSCSI settings can be configured manually or retrieved dynamically from a
DHCP server.

Intel PRO/1000 GT Specifications

General

Interface	PCI
Data Rate	10/100/1000 Mbps
Connector	RJ-45
Network Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Form Factor	Plug-in card
Device Type	Network adapter
Data Link Protocol	Ethernet, Fast Ethernet, Gigabit Ethernet
Data Transfer Rate	1 Gbps
Bus Type	PCI
Full Duplex	Yes
Wake-on-LAN	Yes
Ports	1 x RJ45
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Operating Systems Supported	Windows, Linux, NetWare
Jumbo Frames	Yes, up to 9KB