Intel S5000XVN - Workstation Board Motherboard - Figure 3. Configuration Jumpers

Intel
®
Workstation Board S5000XVN 7
Figure 3. Configuration Jumpers
Password Clear
(J1D2)
1 - 2 Protect password: These pins should be jumpered for
normal operation.
2 - 3 Erase password: If these pins are jumpered for 5 to 10
seconds, the password will be cleared on the next
workstation reset. These pins should not be jumpered for
normal operation.
The workstation does not need to be reset with the
jumpers on these pins for the password to be cleared. To
use this jumper to reset the password: Power down the
workstation. Place the jumper on pins 2 - 3. Power on the
workstation and wait 5 to 10 seconds. Power down the
workstation. Move the jumper back to pins 1 - 2. Power on
the workstation.
BMC Force Update
(J1E3)
1 - 2 Disable force update: These pins should be jumpered for
normal operation.
2 - 3 Enable force update: Jumpering these pins forces a BMC
update.
Jumper Name Pins What Happens at System Reset