94
- Threshold Setting: set the threshold level for detecting and tracking the satellite
signal.
· DVB Detect Level: displays and sets signal detection threshold
level when DVB tracking mode is in use.
· DVB Tracking Level: displays and sets signal tracking threshold
level when DVB tracking mode is in use.
- Search Parameter:
· Wait time: set the time-out for automatic initiation of a search after
the signal level drops below the pre-dened threshold value.
· Search Step: set increment step size.
· Type 1, Type 2 & Type 3 (Search 1, 2 & 3) Range: set Search 1, 2 & 3
search range. Search 2 and Search 3 are conducted in a two-axis
pattern consisting of alternate movements in azimuth and elevation as it
forms an expanding square.
- Threshold Settings
· Initial Sat Count: Set the threshold count for maintaining tracking.
· WRS Detect Level: Set the WRS detection level.
· Voltage Threshold: Set the voltage threshold. The voltage threshold is to
distinguish the voltage between 13V and 18V.
· DiSEqC Threshold: Set the DiSEqC threshold. The DiSEqC threshold is
to distinguish the 0KHz tone and 22KHz tone.
- Flag Settings
· Use WRS Method: Use WRS method is to determine whether the system
uses “WRS Detect Level” or not. Use WRS method and “WRS Detect
Level” are pair functions.
· Use Offset Difference: Use offset difference is to determine whether the
system uses “Offset Difference” or not. Use Offset Difference and “Offset
Difference” are pair functions.
To Next Page
Loading...
Need help?
General
