3. Satellite (Satellite View)
The name, longitude, Skew Offset, Polarity, verication method of the satelite
and local frequency are displayed. Tick the “Edit Satellite” box to edit the satellite
information. After modifying the value.
- LNB Local Frequency: Displays or sets LNB local frequency and its corre-
sponding LNB voltage supplied. You may select pre-programmed LNB LO settings
from the drop down list. This procedure is same for both the Intellian Global VSAT
PLL LNB and any other LNB.
- Transponder Information
· Register for Sat A & Register for Sat B: register the selected satellite for
A or B.
· Transponder information consists of frequency, symbol and NID
(Network ID) of a transponder in tracking the satellite. There are four
groups of transponder information. ‘Vertical/RHCP’ is applied when the
IRD supplies 13V, and ‘Horizontal/LHCP’ is applied when the IRD
supplies 18V. ‘LOW’ is applied when DiSEqC signal is not detected from
IRD. ‘HIGH’ is applied when the DiSEqC signal is detected from the IRD.
After modifying information, press the ‘Edit Satellite Information’ button,
then new information is updated in the antenna.
To Next Page
Loading...
Need help?
General
