5. OPERATION INSTRUCTION
Please follow the steps below before starting.
a. The scale is placed on a solid surface
b. Use adjustable feet and referring to the bubble level to make sure scale is in a level position
c. Power on the scale and wait for the counting down
d. Scale is in zero weight status and display showing zero indicator
e. If zero indicator is not on, press ZERO to set the display to zero
f. If zero weight status cannot be obtained, change the location and try again
WEIGHING UNIT SELECTION
Press MODE to switch between metric and imperial weighing units.
TARE FUNCTION SETTING
This scale equips with auto tare and manual tare. (please refer to F9 of internal setting)
a. If auto tare function is enabled, the first weight being placed on platter will be automatically
tared
b. If manual tare is needed, place the load container on the platter first and press TARE to tare off
the weight. After weight is tared, NET indicator will appear indicating the weight showing on
display is net weight
HOW TO CLEAR TARE FUNCTION
a. To clear auto tare, remove the initial weight/load from the platter and NET indicator will
turn off. Press ZERO to return to zero weight status if ZERO indicator does not appear.
b. To clear manual tare, remove everything from platter and press TARE, the NET indicator will
turn off. Press ZERO to return to zero weight status if ZERO indicator does not appear.
To Next Page
Loading...
Need help?
General
