MEMORY FUNCTION
How To Save A Weighing Result To Memory
a. Place a load on the scale and result will show on the display
b. Wait the Stable signal appears then press M+
c. Scale displays “P. X”, which indicated the total number of transactions accumulated in memory.
d. Weight result is now saved to memory and M+ indicator appears indicating memory contains
data
e. Remove the load and scale will return to zero weight status
f. Put on another weight and press M+ to save the next weight
HOW TO RECALL A WEIGHING RESULT FROM MEMORY
a. Press MR at any time to recall the total result saved in memory, MR indicator appears
indicating the value shown on display is total result.
b. Result will remain on display for a short while before return to the previous screen
HOW TO CLEAR WEIGHING RESULT FROM MEMORY
Follow the below steps to clear saved data from memory after all transactions are completed.
a. Press MR first to recall the total saved result from memory, the MR indicator will appear
b. Press MR and TARE keys simultaneously (MC) to clear the memory and M+ indicator will
turn off indicating there is no data in the memory.
PIECE COUNTING FUNCTION
AGS is equipped with simple piece counting function, please follow the below procedure to enable
the function and sampling method.
a. AGS is on and both Zero indicator and Stable indicator are on
b. Press MODE until display shows PCS as weighing unit on the display
c. Press and hold MODE and display shows S= 10, this means count 10pcs of the same item to
put on platter for sampling the average unit piece weight
d. If 10pcs is not the prefer sampling quantity, continue to press M+ and display will show
S=20, S=50, S=100, S=200, S=500. When the ideal quantity is reached, press MODE to
confirm and put the sample quantity on platter.
e. Scale will begin the sampling process to calculate the unit piece weight, when the sampling
is done scale will show the sampled quantity on display
f. Remove the load and put new batch, display will show the batch quantity.
g. If display shows a value while platter is empty, press ZERO to zero off the weight.
h. If a new sampling is needed, press and hold MR to start new sampling by following step c to
d.
To Next Page
Loading...
Need help?
General
