Intelligent Weighing Technology AGS Series User Manual

F2. Display Segment Check
User can enter this function to check to see if the display and backlight (if purchased) are
functioning properly.
F4. Select Auto Power Off Setting
The scale is equipped with Auto Power Off Function. The scale will power off automatically if it is
not used for 4 minutes. (Default)
0oFF -> 5oFF -> 10oFF -> 20oFF -> 30oFF
F5. Transmission Protocol
Under this function, user can select RS-232 baud rate.
4800 -> 9600 -> 19200 -> 38400 bps
F6. Digital Motion Filter
Under this function, user can enable digital motion filtering function if the weighing environment is
unstable. The scale is equipped with 8 filter speeds:
Filt 0 -> Filt 1 -> Filt 2 -> Filt 3 -> Filt 4 -> Filt 5 -> Filt 6 -> Filt 7
F7. RS-232 Transmission Mode
There are four selectable transmission modes to choose according to end user preference.
Conti - continuous transmission when weight is stabilized
Auto - sends data upon stable weight reading
P out - sends data when press M+
CMD - sends data upon computer’s request
Conti -> Auto -> P out -> CMD
F8. Enable/disable UTP printer mode
Use this function to enable / disable UTP printer protocol.
UTP -> UTP OF
F9. Select Auto Tare Function
This scale is equipped with auto tare function which tares off the initial weight automatically when

Intelligent Weighing Technology AGS Series Specifications

General

Brand	Intelligent Weighing Technology
Model	AGS Series
Category	Scales
Language	English