Intelligent USB-DMX interface - III Role Played by the LEDs

Hardware III Role played by the Leds
III Role played by the Leds
 
Role played by the 3 Leds on the interface
· The yellow Led (in the middle) indicate that the interface is properly-powered.
· The red Led situated by the "DMX" connector blinks to indicate that the DMX signal is being sent. No
blinking corresponds to interface-failure.
· The green Led by the "USB" connector should blink rapidly when the interface is controlled by a
software. In stand alone mode, this green led blinks several times to indicate active scene number.
Page 4