- 59 -
Camera -> MPEG4 -> Computer View (Style 1):
The RTSP and RTP options are for advanced users only. If you are not familiar
with any of these terms, including Multicast and Unicast, there is a good chance
that you do not need these functions of the camera.
RTSP: This is only shown if the RTSP mode is enabled in the general
settings. When activated, you can define which port you wish
to use for the RTSP protocol. The standard port is 554, but
you can use a different port, if desired.
The viewer authentication controls whether or not a valid user
name and password are required in order to access the
camera live image. For security reasons it is recommended to
set this value to “On” (unlike in the screen shot above);
otherwise anyone who knows the network address of your
camera can potentially access the video stream.
RTP: The Real-time Transport Protocol (RTP) defines a standardized
packet format for delivering audio and video over the
Internet. This option is only shown if the RTSP mode is
enabled in the general settings.
Unicast Streaming: Define the port range for standard Unicast
streaming here.
Multicast Streaming: Set to “On” to enable it.
Note: If the camera has firmware 1.6.16.05 or newer installed, the RTSP and
RTP options can be found on the Camera -> General page.
To Next Page
Loading...
Need help?
General
