IntelliPEAK DirectLink WiFi
IntelliPEAK DirectLink Applications Guide
IntelliPEAK DirectLink can be installed to control the following loads.
It requires connection to line power and must be installed by a trained and experienced
technician. Do not under any circumstances open the door and touch any components
inside, as line voltage (120 – 240 VAC) is present. You could damage this product or cause
a hazardous condition if you fail to follow these instructions.
Need Help? For assistance with this product, please visit http://www.comverge.com or call?
HVAC
For HVAC, IntelliPEAK DirectLink is typically installed outside, near your compressor. It is
wired to the same power source as the compressor and relays inside IntelliPEAK will
intelligently reduce the compressor run time during a control event to reduce the demand on the
electrical grid during event periods. Relay(s) inside the device will interrupt the control signal
from the thermostat to the compressor and will only disable the compressor periodically during a
control event. The indoor fan will continue to run during this time. The indoor temperature is
expected to rise a few degrees during the event, depending on the amount of insulation in the
premise.
To Next Page
Need help?
General