Intenso Memory 2 Move Pro - SD Card Backup

EN- 7
9.3 LED PANEL
Power LED:
- LED Off: The device is switched-off or no power
Green Color:
- Off: Battery is fully charged
- Slowly Blinking: Battery charging
- Blinking Fast: Device Shutting-Down
Red Color:
- Steady Light: Less than 30% available power
- Blinking Fast: Will soon shut-down, must be charged
immediately
HDD LED:
- Blinking: Read/Write activities
- Steady Light Connected with PC
- LED off HDD is in sleep mode
Wi-Fi LED:
- LED Off: The device is switched-off or no power
- Blinking blue: Starts the Initialization process
- Steady blue Light: Initialization process completed
Ready to use, Wi-Fi signal is normal
Internet LED:
- LED Off: No internet connection
- Blinking green: establishing connection
- Steady green Light: Connection established
10. SD CARD BACKUP
Please carry out the following steps to backup the data saved on your SD card on Memory 2
Move Pro.
1.) Please start Memory 2 Move Pro and wait for the appliance to be ready for use.
2.) Insert the SD card into the Memory 2 Move Pro card slot.
3.) Now shortly press the power bottom twice to start backup.
Indication: As long as the white LED of Memory 2 Move Pro flashes, your data are copied
from the SD card to the memory of Memory 2 Move Pro. Please do never remove the SD
card from the appliance during an active backup. This can cause damages and subsequent
data losses.