PUBLIC ADDRESS AMPLIFIER
7
PA-612/624
Connecting Speakers
Connecting Speakers
Before connecting speakers, disconnect the AC power cable. Note the proper connecting terminals as shown
b
elow. Make certain that the total impedance is not less than the rated impedance indicated.
HIGH IMPEDANCE SPEAKER INSTALLATION
- Please set up the unit according to the diagram below, be aware and monitor the voltage and impedance
of output terminal.
- Until the sum of the output up to 120W(PA-612) or 240W(PA-624), High impedance speakers can be
connected.
- Please do NOT load over 120W(PA-612) or 240W(PA-624) in total.
- Please do NOT use 4Ω output and High impedance at the same time.
- Please check wires not to short-circuit.
* In Western Hemisphere(North America, South America and Caribbean), the jack has only 3 terminals
because there is no 100V output.
* "Class 2 Wiring" means that TERMINALS provided the audio output power exceeds 10W per channel
under normal operating conditions or the apparatus is intended to be installed or interconnected in the
field by a SKILLED PERSON.
*
*
PA-612
PA-624
PA-612_624_E_PA-612_624_E 10. 7. 13. 오후 6:20 페이지 10
To Next Page
Loading...
