13
RM-88
REMOTE MIC STATION
4. ADDRESS AND CHIME SWITCHES
The position of these switches will determine the ADDRESS assigned to the remote and the status of the
CHIME.
- Address and Chime Switch Position Legend
Move switch #4 to the "on" position to assign address #1 to the remote. Address #1 will correspond to the
#1 BUSY indicator on the front of the remote. Each remote requires a unique address so the next remote
should be assigned address #2. This process may be repeated for up to a maximum of four remotes since
there are four addresses. It is important that the same address is not assigned to more than one remote.
A CHIME tone may be used to precede a Microphone Paging. Move switch #8 to the "on" position to enable
the CHIME feature and the "off" position to disable the CHIME.
Switch Number
1
2
3
4
5
6
7
8
Functions
Not used (Used only for Program)
Not used (Used only for Program)
Not used (Used only for Program)
Remote Mic Station #1
Remote Mic Station #2
Remote Mic Station #3
Remote Mic Station #4
On : Chime Enable / Off : Chime Disable
To Next Page
Loading...
