Interacoustics Affinity Compact - Page 83

D-0123234-D – 2020/05
Affinity Compact - Instructions for Use - EN Page 79
To ensure compliance with the EMC requirements as specified in IEC 60601-1-2, it is essential to use
only the following accessories:
Item
Manufacturer
Model
Audiometric Headset
Interacoustics/ Radioear
DD45
Audiometric
Insert-Headset
Radioear IP30
Bone conductor
Radioear
B71
High Frequency Headset w. flexible
coiled cord
Koss R/80
Insitu Headset
Interacoustics/ Radioear
IHM65
Monitor Headset
w. microphone
Sennheiser
(Interacoustics: MTH400m)
PC3
Monitor Headset
Sennheiser
PX30
High End Microphone
Interacoustics
SRM-1
Electret Microphone, grey clip-on
type.
Interacoustics EM400
½” Coupler Microphone
Interacoustics
-
Ref Microphone
Interacoustics
(1010)
Patient response switch
Interacoustics
APS3
Loudspeaker
Radioear
Any
USB cable (PC)
Interacoustics
type A-B
Conformance to the EMC requirements as specified in IEC 60601-1-2 is ensured if the cable types
and cable lengths are as specified below:
Description
Length (m)
Screened (Yes/No)
Audiometric Headset
2.0
Y
Audiometric
Insert-Headset
2.0 Y
Bone conductor
2.0
N
High Frequency Headset w. flexible
coiled cord
1-2.9 Y
Insitu Headset
2.9
Y
Monitor Headset
w. microphone
2.9 Y
Monitor Headset
1.0
Y
High End Microphone
5.0
Y
Electret Microphone, grey clip-on
type.
2.0 Y
½” Coupler Microphone
0.17
N
Ref Microphone
0.07
N/A
Patient response switch
2.9
Y
Loudspeaker
2.0
N
USB cable (PC)
1.9
Y