D-0101246-Q – 2022/05
Callisto™ Instructions for Use - US Page 45
The Graph shows measured HIT curves. The X
axis shows the f requency and the Y axis shows
output or gain, depending on which measurement
was done.
is printed above the graph
together with a right/lef t indication. In this example
the OSPL90 is dis
played for the lef t ear.
using the slider on the right
NOTE: for the industry standard protocols (ANSI
and IEC), the input level is dictated by the standard
and cannot be changed.
on the left hand side allows
for scrolling the graph up or down ensuring that the
curve is always visible i
n the middle of the screen.
Measurement details: In this table the curve
details can always be viewed. This way the
professional always has an overview of what is
being measured. Read information such as Input
Level, Max SPL, Curve Type, Stimulus, and
Curve
A Curve Comment f or each curve can be typed
into the comment section on the right hand side.
Select a curve using the curve tag boxes under
Curve display options and write a comment in the
comment section.
The comment will then appear in the comment
section whenever the curve is selected.
Curve Display Options are found in the lower
right hand corner.
If you have measured more curves of the same
type (e.g. Frequency response curves), they will
be listed by their input level. Tick the ones that are
to be displayed on the graph.
The hardware indication picture indicates whether the
hardware is connected.
When opening the Suite, the system will search for the hardware. If it does not detect the hardware,
then the system will automatically continue in simulation mode.
To Next Page
Loading...
