OPERATIONS INSTRUCTIONS
MD8 INTERCHANGE EQUIPMENT, INC.
1. Blower on—Push Button
2. Blower off—Push an
d Hold Button for 3 seconds
START DRYER:
Blower must be on—
Turn burner switch to right and hold until blue purge light illuminates.
Set temperature on controller by using the up and down arrows. (start at 350 degree).
Set belt speed to
the desired dwell time. This is dependent upon many factors; ink type
material type/color and product type. Consult your ink supplier to determine exact ink
requirements
.
T
o
turn
of
f
- tu
rn burn
er switch to left. This will
turn off heat (gas or electric). Blower will
time out (remain on) for 10 minutes and then shut down. The belt will continue to run as
long as power is supplied to dryer. After blower has timed out, power may now be
disconnected from dryer.
Operating Instruction
To Next Page
Loading...