Interlogix ATS1170 - Page 4

4 ATS1170 One Door RAS Programming Guide
Note: The menu is applicable only in online access control. In case of offline
access control all options work as Only Request To Exit.
Display card format
These options provide information only. The options can only be changed
through DIP switch C. Effectively, this is displaying the position of DIP switch C.
Select menu 3–Display Card Format to view the format selected using DIP
switch C. The display will show one of the following:
Wiegand Reader
#-Exit
(default)
— or —
Magnetic Stripe
#-Exit
Display card type
These options provide information only. The options can only be changed
through DIP switch B. Effectively, this is displaying the position of DIP switch B.
Select menu 4–Display Card Type to view the selection using DIP switch B.
The display will show one of the following:
Aritech
#-Exit
(default)
— or —
Financial
#-Exit
Selecting LED 1 Options
Select menu 5 to determine LED 1 options. The display will show one of the
following:
LED 1 Armed
*-Change, #-Exit
(default)
— or —
LED 1 Armed + Door Unlocked
*-Change, #-Exit
• LED 1 Armed: LED 1 is on when the area is armed, and LED 2 flashes when
access is granted.
• LED 1 Armed + Door Unlocked: LED 1 is on when the area is armed, and
flashes when access is granted.