ATS1170 One Door RAS Programming Guide 5
Selecting LED 2 Options
Select control panel menu 6–LED 2 Options to determine LED 2 operation. The
display will show one of the following:
LED 2 Door Unlocked Only
*-Change, #-Exit
— or —
LED 2 Door Unlocked + Disarmed
*-Change, #-Exit
• LED 2 Door Unlocked Only: LED 2 flashes when access is granted, and it is
off at all other times.
• LED 2 Door Unlock + Disarmed: LED 2 flashes when access is granted, and it
is continuously on when the area is disarmed.
Press Enter to return to the main menu.
Restoring factory default settings
Select menu 8–Factory Defaults to restore default settings and clear the
database of all card numbers programmed by an installer. The display will show
the following:
Clear Database?
*-Yes, # -No
Press Enter to return to the main menu without making any changes or press
Menu* key to clear the database and return all settings to the factory default. If
you press the Menu* key to clear the database, it will ask you for confirmation.
For default values, see “Default settings” on page 8.
Display version number
Go to ATS1170 menu 9–Version number. The display will show the following:
Tecom Systems
ver. ATS1170.Vxx
Where “Vxx” is the version number. For example, V01 is the first release.
To Next Page
Loading...