Chapter 5: Menu reference
252 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
entry time has expired, alarm confirmation is enabled. However: entry/exit and
access zones cannot generate B-alarms.
If this option is set to No, the start of the entry timer disables any alarm
confirmation until the area is set again.
8.7.6.5 Access to EE
5 Access to EE
>Entry/Exit<
The Access to EE option defines the functionality of the access zone in the area
(if available) when an entry/exit (EE) zone is inhibited at the end of the AB time
(auto-inhibit function). The following values are allowed:
• Entry/Exit: an access zone acts as an entry/exit zone, if the entry/exit zone is
inhibited.
• Access: an access zone does not change its functionality and causes an
alarm when activated while no EE timer is running.
8.7.6.6 TA confirm
If the TA confirm option is set to Yes, tamper alarm (TA) can report a B-alarm for
burglary alarm (BA), and vice versa.
8.7.6.7 Sirens
The Sirens menu allows you to select per area when the siren is activated: on A-
alarm or on B-alarm.
Note: Option B-alarm is valid only if AB mode is enabled. See “8.7.6.1 AB mode”
on page 250.
8.7.6.8 Call CS message
If the Call central station message option is set to Yes, in case of alarm the
keypad displays a message with advice for the user to call the central station
when a report has been sent.
8.7.6.9 Reporting delayed
Enable a 30-second delay before alarm reporting required by ACPO regulations.
To Next Page
Loading...
Need help?
General
