Chapter 5: Menu reference
272 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
menu below. If this option is set to Dynamic, the DHCP is used to obtain the DNS
IP address.
If DHCP is disabled, this menu is not available.
9.3.n.5.2 DNS server
2 DNS server
>000.000.000.00<
The DNS server menu allows you to set the DNS address if it is different from the
DNS provided by DHCP server, or if DHCP is disabled in menu “9.3.n.4.1 IP
config” menu on page 271.
9.3.n.6 NTP config
The NTP config menu is used to configure the NTP (Network Time Protocol)
server.
The following options are configurable in this menu.
9.3.n.6.1 NTP config
If the IP configuration in menu “9.3.n.4 IP config” on page 270 is set to Dynamic
(DHCP is enabled), you can set the NTP configuration option to Static to override
the automatic NTP configuration by DHCP server. Set the NTP address in the
menu below. If this option is set to Dynamic, the DHCP is used to obtain the NTP
IP address.
If DHCP is disabled, this menu is not available.
9.3.n.6.2 NTP server
2 NTP server
>000.000.000.00<
The NTP server menu allows you to set the NTP address if it is different from the
NTP provided by DHCP server, or if DHCP is disabled in menu “9.3.n.4.1 IP
config” menu on page 271.
9.3.n.7 Firewall
The Firewall menu is used to configure the built-in firewall. The firewall allows
only communication from hosts that are configured as appropriate PC
connections in “9.4.1.n.4 Destination/IP” on page 285.
The following options are configurable in this menu.
To Next Page
Loading...
Need help?
General
