Chapter 5: Menu reference
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual 277
9.3.n.5.3.3 Check number
3 Check number
>+48600000000<
The Check number is the phone number that is used for sending credit check
SMS messages, if this check mode is chosen in “9.3.n.5.3.2 Check mode” on
page 276.
9.3.n.5.3.4 Request code
The Request code for the account check must be configured in this menu. It
allows you to enter numbers as well as “*” and “#” signs (for example, *101#).
Contact your GSM provider to find out how to check your account.
9.3.n.5.3.5 Check period
The Check period (in days) defines how often the system automatically checks
your account.
Note: When the system performs an automatic account check, the response is
treated as an SMS from an unauthorized source, and therefore is forwarded to
the Supervisor. Please make sure that option “9.3.n.6.2 SMS forwarding” on
page 278 is enabled, otherwise the account state response will be lost.
9.3.n.5.3.6 Check time
The Check time is the time of day in 24 h format when the system performs the
automatic account check described in “9.3.n.5.3.5 Check period” above.
9.3.n.5.4 Jamm detection
The menu allows you to configure GSM jamming detection parameters.
9.3.n.5.4.1 Jamm detection
If set to On, the panel raises tamper alarm when GSM jamming is detected.
Note: The dialler must support jamming detection functionality. The detection is
supported in the ATS7310 GSM dialler with firmware version V01.08 or later.
To Next Page
Loading...
