Interlogix ATS3500A-IP-MM Installation And Programming Manual

Chapter 3: System functions
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual 89
Type
Description
Available parameters
Part set 2
Part set 2 for areas [1][2]
1. Areas selection
2. User code requirement
Inhibit
Inhibit zones [1][3]
None
Test call
Execute a test call [3][4]
None
PC connection
Establish connection with the
PC [1][3]
None
Service in
Allow service in [5]
None
Panic
Activate panic alarm
None
Chime area
Change a chime functionality
status in the area
1. Areas selection
2. Status change: Clear, Set, or Toggle
Chime keypad
Change a chime functionality
status on the keypad
1. Keypad selection
2. Status change: Clear, Set, or Toggle
Set without exit
Immediate set (without exit
time) [1]
1. Areas selection
2. Area groups selection
3. User code requirement
Fire reset
Reset fire detectors [1]
1. Areas selection
Show open zones
Show open zones [1]
1. User code requirement
Active alarms
Show zones in alarm state [1]
1. User code requirement
Active faults
Show faulty zones [1]
1. User code requirement
Alarm memory
Show acknowledged alarms [1]
1. User code requirement
Alarms to ACK
Show unacknowledged alarms
[1]
None
UG control
Change user group privileges
1. UG identifier
2 and further - user group privilege.
Choose a privilege, and then change it.
See “3.2.n.6 User group options” on page
169 for more details.
Note that the user group type must allow
this change. See “3.2.n.2 User group type”
on page 168 for details.
Keypad control
Change keypad options
1. Keypad identifier
2. State change: lock or unlock
Walk test
Run walk test [1]
1. Area selection
Output test
Test outputs [1][4]
1. Output selection.
4 outputs can be assigned.
These outputs are switched on
simultaneously for the longest time period
configured in “8.1.2.1 Activation” on page
233.
2. User code requirement.

Interlogix ATS3500A-IP-MM Specifications

General

Brand	Interlogix
Model	ATS3500A-IP-MM
Category	Security System
Language	English