Chapter 5: Menu reference
246 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
• 15 minutes
• 30 minutes
• 1 hour
• 2 hours
• 3 hours
• 4 hours
See “Autoset” on page 91 for more details.
The user must have a privilege for full setting to be allowed to postpone the
autoset. See “3.2.n.6 User group options” on page 169 for more details.
8.5 Access options
1>Access timers
2 DGP options
The menu contains various access control options.
8.5.1 Access timers
The menu contains access timer settings.
Note: All timers are programmed in seconds. The allowed ranges are 0 to 127 s.
8.5.1.1 Card to PIN
This setting is only applicable when a user is required to present a card and enter
a PIN to gain access.
The Card to Pin Time is the amount of time allowed between presenting a valid
card to a door reader and entering a valid PIN (last digits) on the keypad. If the
PIN is not entered before the time expires, the user will need to repeat the door
opening function.
8.5.1.2 Two cards
This setting is only applicable when two users must present their card or PIN to
open a door or when a user is identified as a visitor or guard and must be
accompanied.
The Two cards time is the amount of time allowed between the first user
presenting a card or entering a PIN and the second user presenting a card or
entering a PIN. If the second card/PIN is not presented before the time expires,
the door opening function will have to be repeated.
To Next Page
Loading...
