STEP 5: Setup the recording parameters for
each recording level.
• Camera Setup/Camera Recording Setup -
For each camera enter the values.
• Values selected are - resolution (TL-Hi)
and motion (event).
• Make sure to click “Save.”
STEP 3: Plug the cameras into the POE ports
on the back of the recorder (it is recommend-
ed to plug them into the ports on the back in
order so that Camera 1 is in port 1, etc. It will
make it easier to troubleshoot later).
STEP 2: Use Internet Explorer (or Firefox
ESR52)(or Chrome with IETab extension) to
login to the configuration page of the recorder.
• Network Settings –Set your Preferred and
Alternate DNS Servers (use any valid DNS
server – Free Google Versions 8.8.8.8 &
8.8.4.4) – This is necessary for DDNS,
NTP, & Push Notifications. Click “Save.”
• Device Management/Time & Date Settings
– Set the time & date and check Auto
DST. Click “Save.”
• Network Settings/NTP – Click Enable
NTP. Click “Save.”
STEP 1: Use Device Manage to activate the
recorder (assigning it a password) and set the
IP of the recorder to an address within the
subnet of the premise.
Quickstart Guide
Interlogix TruVision TVN-11/TVN-22S
STEP 6: If you want to record on motion only
(no time lapse) adjust the recording schedule
(recording/recording schedule) to show all yel-
low (Event).
STEP 4: After the cameras come up online,
with video, go back into configuration of the
recorder and change each camera from Plug
and Play to Manual - *IMPORTANT*
• Camera Setup/IP Camera Status - High-
light the camera and click “Modify.”
• Change the adding method to Manual, en-
ter the password (newer cameras will have
the same password as the recorder from
the initial setup, older cameras may still
have the default password 1234). Click
“Ok”
To Next Page
Need help?
General
