Interlogix TVD-5303 - Mounting the IP VF Lens Bullet Camera and the IP Motorized Lens Bullet Camera (Without the Supplied Back Box)

30 Installation Guide
3. Loosen the large nut at the base of the mounting bracket
to adjust the camera’s viewing angle.
Pan direction: 0 to 360° adjustable
Tilt direction: 0 to 90° adjustable
Rotate direction: 0 to 360° adjustable
4. Adjust the lens to the desired surveillance angle. Tighten
the adjustable nuts to complete the installation.
Mounting the IP VF lens bullet camera
and the IP motorized lens bullet camera
(without the supplied back box)
To mount the IP VF lens bullet camera to a surface:
1. Use the supplied template to mark out the mounting area.
Drill mounting holes in the surface using the holes
labelled number “1” on the drill template.
0° ~ 360°
0°~90°
0° ~ 360°