xGenConnect Installation and Programming Guide iii
Removing xGenConnect from existing Z-Wave network as
Secondary Controller 77
Adding xGenConnect to existing Z-Wave network as Primary
Controller 78
Relinquish Primary Control of xGenConnect to another
Controller 79
Creating a Device Association 81
Replacing a Failed Node 82
Creating a Device Association 82
Removing a Failed Node 82
Rediscover Z-Wave Nodes 83
Backup Z-Wave Network 84
Reset Z-Wave Network 84
Restore Z-Wave Network 84
Send User PINs to Z-Wave Door Lock 85
Programming Scenes 87
xGenConnect with Amazon Alexa 91
xGenConnect Works with Google Assistant 93
Programming Instructions 98
Programming Instructions for System Options 98
Programming Instructions for Permissions 102
Programming Instructions for Menus 104
Programming Instructions for Holidays 106
Programming Instructions for Users 109
Programming Instructions for Zones 112
Programming Instructions for Custom Zones 115
Programming Instructions for Areas 118
Programming Instructions for Schedules 121
Programming Instructions for Arm-Disarm 125
Programming Instructions for Communicator 130
Programming Instructions for UltraSync 133
Programming Instructions for Event Lists 135
Programming Instructions for Channels 137
Programming Instructions for Zone Reporting 141
Programming Instructions for System Event Reporting 143
Programming Instructions for Actions 145
Programming Instructions for Action Groups 147
Programming Instructions for Scenes 149
Programming Instructions for Outputs 150
Combining Actions with Schedules 151
Walk Test 151
User Reporting 152
To Next Page
Loading...
