Intermec CK30

Chapter 2 — Replacing Parts
Screw
(2 places)
Screw
(2 places)
Screw
(2 places)
Antenna
Antenna
ground
plane
Bottom
cover
Retainer
clips
Mini PCI
shield
assembly
Mini PCI
radio
assembly
4 Use the antenna cable remover tool to carefully lift the antenna off of
the mini PCI radio assembly. Insert the prongs under the antenna cable
socket and lift gently.
Note: Do not pull on the wire because the cable will break. If you do
not have an antenna cable remover, insert your fingernails under the
antenna cable socket and lift gently.
5 Open the radio card retainer clips and pull the mini PCI radio assembly
away from the connector.
6 Insert the new mini PCI radio assembly into the connector until it
cannot go in any further and then push it down until the radio retainer
clips lock in place.
7 Attach your new antenna cable to the mini PCI radio assembly.
8 Replace the mini PCI shield assembly.
9 Replace the antenna ground plane and antenna.
10 Close the CK30. For help, see “Closing the CK30” on page 27.
CK30 Handheld Computer Service Manual 11