Intermec CK30

Chapter 2 — Replacing Parts
Replacing the Bezel Assembly
To replace the bezel assembly, you need one of the following parts
depending on the CK30 configuration:
• CK30 programmable 42-key bezel assembly (P/N 073297-001)
• CK30 international 42-key bezel assembly (P/N 073298-001)
• CK30 3270/5250 42-key bezel assembly (P/N 073299-001)
• CK30 ANSI 42-key bezel assembly (P/N 073300-001)
• CK30 programmable 50-key bezel assembly (P/N 073293-001)
• CK30 international 50-key bezel assembly (P/N 073294-001)
• CK30 3270/5250 50-key bezel assembly (P/N 073295-001)
• CK30 ANSI 50-key bezel assembly (P/N 073296-001)
• CK30 programmable 52-key bezel assembly (P/N 073289-001)
• CK30 international 52-key bezel assembly (P/N 073290-001)
• CK30 3270/5250 52-key bezel assembly (P/N 073291-001)
• CK30 ANSI 52-key bezel assembly (P/N 073292-001)
To replace the bezel assembly
1 Separate one of the top corners of the CK30 overlay from the top cover.
2 Pull up on the overlay until you have completely separated the overlay
surrounding the display from the top cover.
Bezel
assembly
3 Using the top part of the overlay as a handle, pull up until you start to
pry up a corner of the keypad bezel.
CK30 Handheld Computer Service Manual 17