Intermec CK30

Chapter 2 — Replacing Parts
4 Turn the scan engine assembly over and remove the two Phillips screws
that attach the scan engine and ground spring to the small scan mount
bracket.
5 Disconnect the scan flex cable from the scan engine assembly.
Screw
(3 places)
Screw
(2 places)
EV10 scan
flex cable
Engine
insulator
Engine
ground
spring
EV10 scan
engine assembly
Small scan
mount
bracket
6 Assemble the new scan engine for replacement:
a Remove the backing from the engine insulator and attach it to the
top of the scan engine assembly.
b Connect the scan flex cable to the scan engine assembly. Make sure
you completely insert the scan flex cable up to the white alignment
mark.
7 Insert the EV10 scan engine assembly into the ground spring, place it
inside the scan mount bracket, and attach it with the two screws
removed in Step 4.
8 Insert the scan engine assembly into the bottom cover and attach it with
the three screws removed in Step 2.
9 Close the CK30. For help, see “Closing the CK30” on page 27.
24 CK30 Handheld Computer Service Manual