Chapter 2 — Replacing Parts
4 Replace the six Torx screws (four self-tapping and two machine) and
tighten to 9 in-lb.
5 Replace the four Phillips screws and tighten to 2 to 3 in-lb.
Screw
(4 places)
Screw
(2 places)
Screw
(2 places)
Screw
(2 places)
6 While holding the CK30 in one hand, insert the tabs on the bottom of
the battery into the CK30 and snap the battery into place.
28 CK30 Handheld Computer Service Manual
To Next Page
Loading...
