Chapter 1 — Using the Computer
CK3 Mobile Computer User’s Manual 17
Scanning With the Linear Imager
If your CK3 has a linear imager, use the following procedure to
practice scanning a bar code.
To scan bar code labels with the linear imager
1 Press to turn on the CK3.
2 Point the scanner window at the bar code label and hold the CK3
at a slight angle 15 to 25 cm (6 to 10 in) from the label.
3 Press the Scan button on the keypad, or pull the trigger on a
handle, and direct the red beam so that it falls across all bars in the
bar code label.
Use this test bar code:
Code 39 Test Bar Code
*123456*
*123456*
When the CK3 successfully reads a bar code label, you hear a high
beep and the green Good Read light turns on briefly.
4 Release the Scan button or trigger.
To Next Page
Loading...
