Chapter 1 — Using the Computer
CK3 Mobile Computer User’s Manual 21
4 Aim both the illumination beam and the laser pointer at the bar
code you want to scan.
When the CK3 successfully reads a bar code label, you hear a high
beep and the green Good Read light turns on briefly.
Using a microSD Card
You can use a micro Secure Digital (SD) card to increase file storage
and install software. Your CK3 supports microSD cards that hold up
to 2 GB of information. The microSD card slot is located in the
battery compartment.
To install a microSD card
1 Remove the battery. For help, see “Removing and Installing the
Battery” on page 4.
Note: The center-decoding parameter only decodes a bar code if
the laser pointer is on the bar code and the illumination beam
covers the bar code.
Laser pointer
Good read LED
Scan button
To Next Page
Loading...
