Chapter 3 — Configure the Computer
CK3R and CK3X Mobile Computer User Manual 61
Configure WPA or WPA2 Enterprise (802.1x) Security
with Funk Security
Before you set WPA-802.1x or WPA2-802.1x security with Funk, you
need to configure your authentication server and authenticators. To
use TLS protocol, you also need to load a user and root certificate. On
your computer, you need to enable the radio and set the date.
1 Start Intermec Settings.
2 Select Communications > 802.11 Radio > Funk Security.
3 Select a Funk security profile to configure.
4 Enter the SSID.
5 For Association, select WPA or WPA2.
The default encryption is TKIP or AES, respectively.
6 For 8021x, select TTLS, PEAP, EAP-FAST, or TLS.
7 If you selected TTLS, PEAP, or EAP-FAST:
a For Prompt for Credentials, select Enter credentials now.
b Enter a User Name and User Password.
8 If you selected TLS, enter a User Name and Subject Name.
9 For Validate Server Certificate, select Yes.
10 Tap OK.
Configure WPA or WPA2 Personal (PSK) Security with
Funk Security
Before you set WPA or WPA2 Personal (PSK) security, you need to
know the pre-shared key for your access point or passphrase for your
authenticator. On your computer, you need to enable the radio and set
the date.
1 Start Intermec Settings.
2 Select Communications > 802.11 Radio > Funk Security.
3 Select a Funk security profile to configure.
4 Enter the SSID.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
