ii EasyCoder PD4 Cutter Installation Instructions
Intermec Technologies Corporation
Corporate Headquarters
6001 36th Ave. W.
Everett, WA 98203
U.S.A.
www.intermec.com
e information contained herein is proprietary and is provided solely for the
purpose of allowing customers to operate and service Intermec-manufactured
equipment and is not to be released, reproduced, or used for any other pur-
pose without written permission of Intermec.
Information and specifi cations contained in this document are subject to
change without prior notice and do not represent a commitment on the part
of Intermec Technologies Corporation.
© 2005 by Intermec Technologies Corporation. All rights reserved.
e word Intermec, the Intermec logo, and EasyCoder are either trademarks
or registered trademarks of Intermec Technologies Corporation.
roughout this manual, trademarked names may be used. Rather than put
a trademark (™ or ®) symbol in every occurrence of a trademarked name, we
state that we are using the names only in an editorial fashion, and to the ben-
efi t of the trademark owner, with no intention of infringement.
ere are U.S. and foreign patents pending.
To Next Page
Loading...
Need help?
General
