Intermec EasyCoder PD4 - Before You Begin; Safety Summary; Energized Equipment Safety

2 EasyCoder PD4 Cutter Installation Instructions
Chapter 1 — Installation
Installing the Cutter
1 Unpack your EasyCoder PD4 cutter kit and check to see that all parts are
included. If not, contact your sales representative.
Front cover
Screw
2 Make sure the printer is unplugged. Remove the screw
that holds the front cover. Remove the front cover.
Cutter
mechanism
Cutter cover
2 screws
with washers
2 cable
clips
Cutter tray