EasyCoder
®
PD41/PD42
Internal Rewinder Installation Instructions
These instructions tell you how to install the Internal Rewinder in an
EasyCoder PD41/PD42 printer. Use the internal rewinder to operate the
printer in peel-off mode or batch takeup mode. The kit includes the
following:
Required Tools
To install the interface board in your printer, you need:
• Screwdriver, Phillips
Installing the Internal Rewinder
Before you begin installation, please acknowledge the following important
safety note:
Take precautions against electrostatic discharge, for
example, by wearing grounded wrist straps.
Rewinder module with liner
retention clip
Liner retention guide
Four screws (M3x4.5)
To Next Page
