Intermec EasyLAN 10I2 Quick Start Guide

10 EasyLAN 10i2 Ethernet Adapter Quick Start Guide
7 Turn on the printer. The LED on the adapter flashes
and then turns off.
When you turn on the printer with the EasyLAN 10i2
adapter, the adapter runs through a set of power-up
diagnostics for a few seconds. If the adapter is operating
properly, the LED blinks momentarily and then turns off.
The LED blinks whenever there is networking activity.
If you have a DHCP (Dynamic Host Configuration
Protocol) server on your network, the EasyLAN 10i2
adapter receives its TCP/IP settings, including an IP
address, when you plug in the adapter and turn on the
printer. You are now ready to print to your printer. If you
want to print a test label or set a static IP address for the
EasyLAN 10i2 adapter, see the next two sections.
Printing a Test Label
After the LED turns off, print a test label to make sure that
the EasyLAN 10i2 adapter is working. The test label shows
the current Ethernet and network settings of the adapter.
Note: Printers that do not use the Intermec
Printer Language (IPL) or Direct Protocol (DP),
such as the EasyCoder 91, 901, 7422, C4, or PC4
or the ColorCoder V4, cannot print a test label.
To print a test label
• Insert a small, straightened paper clip into the Test
button, and press and release the Test button.
Downloading the IP Address
If you have a DHCP server on your network, the EasyLAN
10i2 adapter automatically connects to the server and
receives its TCP/IP settings, including its IP address. If you
do not have a DHCP server or if you want to configure a
static IP address, you can use ARP (Address Resolution
Protocol) to assign an IP address to the adapter.

Intermec EasyLAN 10I2 Specifications

General

Brand	Intermec
Model	EasyLAN 10I2
Category	Adapter
Language	English