Intermec PB31

Chapter 1 — Using the PB21 and PB31 Mobile Receipt Printer
8 PB21 and PB31 Mobile Receipt Printer User Guide
To change the printer language using ESC/P and a communications
program
1 Connect your printer to your PC using a serial cable. For help, see
“Connecting the Printer Through the Serial Port” on page 29.
2 Start a communications program like HyperTerminal.
3 Enter U-shell. Press the ESC key and type:
{SYS:USH}
4 Send the enable administrator rights command:
su -p pass admin
5 Send the run command to change the printer language:
setlanguage IPL -r
To change the printer language using the display and Fingerprint
1 Press the Setup button. The Setup menu system appears
2 Press until you reach Print Defs.
3 Press to enter the Print Defs menu system.
4 Press until you reach CMD Language.
5 Press to enter the CMD Language menu system.
6 Press until you see the language of you want to select.
7 Press to select the language.
8 Cold boot the printer:
a Remove the printer battery.
b Replace the printer battery.
c Turn the printer on.
To change the printer language using the display and IPL
1 Press the Setup button. The Setup menu system appears.
2 Press until you reach Test/Service.
3 Press to enter the Test/Service menu system.
4 Press until you reach CMD Language.
5 Press to enter the CMD Language menu system.
6 Press until you see the language of you want to select.