Chapter 2 — Configuring the PB21 and PB31
30 PB21 and PB31 Mobile Receipt Printer User Guide
7 PrintSet attempts to connect to your printer. If it cannot find your
printer, click Back to review the communication settings, and
then try again. When PrintSet connects to your printer, click Next.
8 Click Finish. Your printer appears in the My Printers list.
To connect the printer to a PC through the serial port using
HyperTerminal
1 Connect the serial cable to the connector on the back of the
printer and connect the other end to your PC.
2 On your PC, start the communications program.
3 If necessary, configure the port settings so they match those of
your printer:
Bits per second: 115200
Data bits: 8
Parity: None
Stop bits: 1
Flow control: XON_XOFF
4 If you are using HyperTerminal:
a Click OK.
b Click the Settings tab.
c Click ASCII Setup. The ASCII Setup window appears.
d Select these check boxes, and then click OK:
• Send line ends with line feed
• Echo typed characters locally
• Append line feeds to incoming line ends
To Next Page
Loading...
