Chapter 2 — Connecting the Printer
PF8d and PF8t Desktop Printer User’s Guide 45
8 Type ^XSET,USBETHERNET,1 and press Enter.
9 Test your connection by typing UQ in the main window and
pressing Enter. Information about your printer appears.
To send commands
• Type a command in the terminal window and press Enter. For a
list of commands, see the ESim for the PC4, PF8, PD41, and PD42
Printer Programmer’s Reference Manual.
Configuring the Printer
You can configure your printer:
• from the printer home page. Intermec recommends using this
method to configure your printer.
• using PrintSet. PrintSet is available on the PrinterCompanion CD.
The latest version is available from the Intermec web site at
www.intermec.com.
• by sending commands from your PC.
Configuring the Printer From the Printer Home Page
You can configure most network settings from the printer home page.
To configure the printer from the printer home page
1 In a HyperTerminal window, type ! U1 getvar “ip.addr”
and press Enter. The IP address for your printer is displayed.
2 Start a web browser application.
Note: If PrintSet is not available, you can use the temporary
EasyLan Control Center Tool (ECCT) to set the TCP/IP and IP
addresses. The ECCT is available on the Printer Companion CD.
To Next Page
Loading...
