Intermec Sabre 1551C - Section 1: Connecting the Scanner; Scanner Types and Getting Started; Unpacking and Installation Equipment

Co de 39
14
2. Adjust the scanner distance to the bar code and the position
of the laser beam to make sure every bar and space is
scanned.
*HI* *HI*
INCORRECT CORRECT
155XQRG.006
3. When you get a successful read, the laser beam turns off, the
scanner beeps once, and the light turns green.
Hands-Free Scanning
You can use your Sabre 1551C laser scanner with a scanner
stand for hands-free scanning. To order a scanner stand, see
“Accessories for the Scanner” later in this guide.
Note: If your scanner stand does not have a small magnet in the
holder, you need to upgrade your stand using upgrade kit part
number 066799.
To use the scanner stand
1. Place the scanner handle
on the bottom ledge of
the holder and then rotate
the handle in the holder
until it locks into place.
2. Align the scanner and
adjust the column height
so that the pulsating laser
beam covers the entire
label on the base of the
stand.
155XQG.005
Holder