Intermec SF51 - Page 6

6
4 To verify your connection with EasySet, select
Communication > Connect. The Online Setup dialog box
appears.
5 Select the incoming COM port that you previously noted and
click OK.
When the scanner connects to your host PC, it emits a series
of beeps from low to high, and the blue Intermec Ready-to-
Work indicator turns on and stays on.
6 To disconnect from EasySet, select Communication >
Disconnect.
The scanner disconnects from EasySet, emits a series of beeps
from high to low, and the blue Intermec Ready-to-Work
indicator starts blinking.
You are now ready to connect to your application. The method
for connecting depends on your data collection application.
To disconnect from your host PC
•Scan this bar code:
Bluetooth Device Disconnect
\60\02\52\05\00\00\06\00\00\00\00\00\00\00\00\00
The scanner disconnects from your host PC, emits a series of
beeps from high to low, and the blue Intermec Ready-to-Work
indicator turns off.
Connecting From Your PC
You can connect from your PC through your data collection
application or EasySet. This section describes how to connect
using EasySet.
To connect from your PC using EasySet
1 To turn on your scanner, press the Scan button or pull the
trigger. The scanner enters a discoverable state.
2 Start EasySet version 5.4.1 or later. Make sure that SF51 or
SR61 is selected as your product.