SG20B Charge Base Instructions 5
To install using mounting hardware
• Use the mounting template on the back cover to correctly
install mounting hardware.
Charging the SG20B Scanner
When the scanner is correctly docked in the charger it beeps
twice.
If the scanner does not beep when inserted in the charge base
check the following:
• Scanner is correctly inserted in the charger base.
• Power is supplied to the charge base via the correct DC power
supply or USB cable (= 500 mA).
• Battery contacts are clean. To clean the contacts, rub them
with a pencil eraser and remove any eraser debris.
To Next Page
Loading...
