Intermec SR60 Instructions

Learning About the Hands Free Stand
The SR60 Hands Free Stand allows you to use AutoSense mode for the
SR60 scanner. When enabled, AutoSense detects when a bar code is
placed within range and automatically scans without the need to
manually trigger the scanner.
These instructions provide directions for adjusting the stand height,
installing and removing the scanner, and configuring the scanner.
Adjusting the Stand Height
To adjust the stand height
1 Pull and hold the retaining knob while sliding the top assembly to
the desired height.
2 Release the retaining knob and readjust the height so that the
retaining pins latch onto the retaining holes.
SR60 Hands Free Stand Instructions
Retaining knob
Scanner cradle
Retaining
pins

Intermec SR60 Specifications

General

Brand	Intermec
Model	SR60
Category	Barcode Reader
Language	English