Intermec SR61

6
Troubleshooting
If you need more help, please visit our Product Support web site
at intermec.custhelp.com, or call 1-800-755-5505.
Where to Find More Information
Go to the Intermec web site at www.intermec.com to find
manuals as PDF files. To order accessories and printed
documentation, contact your local Intermec sales representative.
Patent Information: This product is protected by one or more
patents. Refer to the SR61 Cordless Scanner User’s Guide (P/N
934-000-xxx) for the list of patents.
Electrical rating:
x 5V, 1.7A
Problem Possible Solution
You scan a data bar code,
the status light flashes red
for 2 seconds, and the
SR61 beeps three times.
The SR61 may not be connected to a host.
Make sure the blue Intermec Ready-to-
Work indicator is on and the SR61 is
linked to your host device.
You pull the trigger and
the status light turns on
and stays red.
The battery is low. Charge the battery
immediately and try scanning again.
You cannot establish a
Bluetooth connection
(the Intermec Ready-to-
Work indicator is not
on).
Scan the following bar code to reset the
SR61 to its default configuration and try
establishing a link again. You will need to
reconfigure the SR61.
Administrator Reset to Factory Defaults
\60\08\55\22