OPTIONAL
EQUIPMENT
FRAME EXTENSION
ATTACHMENT
A-859<S8fl
lllust.
36
Note:
When
using the frame extension
attachment
to convert
a
5
-furrow to
6-
furrow plow,
be sure the pull beam and
crossbar are assembled
in the correct
po-
sition. See
pages
13 and
14
or
17 and
18
as appli-
cable.
Be sure to read "Bottoms
and
Colters", "Rear Furrow
Wheel" and "Gauge
Wheel" for detailed setting
up instructions.
1.
Bolt
the
bottom
to the extension trip
beam.
2. Remove
the
furrow wheel
assembly
with cylinder support from
the end of the
main diagonal member.
Bolt these parts to
the end of the
extension.
3. Bolt the splice plates with extension
to
the end of the
main
diagonal member.
Note
that these plates are "upper" and
"lower" and they must be assembled ex-
actly
as shown
in
lllust.
36.
4. Bolt the colter rail to the trip.
5. Install the gauge
wheel.
6. Bolt the steering pipe pivot arm
to
the
main diagonal
member
locating it
be-
tween the fourth and fifth
beams.
7. Connect the rear steering
pipe.
8. Install and adjust the colter shank
and
colter.
9.
Attach the hydraulic
cylinder.
36
To Next Page